Intrusion Switch; Removing The Intrusion Switch Module - Dell PowerEdge XE9640 Installation And Service Manual

Figure 126. Install the turtle shell
Next steps
1. Install the lower brace cover for Intel GPU configurations
2. Install the storage tray for Intel GPU configurations
3. Follow the procedure listed in the

Intrusion switch

This is a service technician replaceable part only.

Removing the intrusion switch module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the cable cover.
4. Remove the riser 4A for Intel GPU configurations or
5. Remove the turtle shell
NOTE: Ensure that you note the routing of the cable as you remove it from the system board. Route the cable properly
when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Disconnect the intrusion switch cable from the connector on the system board.
2. Using a Phillips 2 screwdriver, remove the screws on the intrusion switch module.
3. Slide the intrusion switch module out of the slot on the system.
After working inside your
Safety instructions.
Before working inside your
from the DLC module 2.
or Install the lower brace cover for NVIDIA GPU configurations
or Install the storage tray for NVIDIA GPU configurations
system.
system.
Remove the riser 4B for NVIDIA GPU configurations.
Installing and removing system components
.
.
145