Novell NETWARE 6-DOCUMENTATION Manual page 3716

073: Unable to allocate memory.
Source:
Possible Cause:
Action:
074: The hardware interrupt cannot be set.
Source:
Possible Cause:
Action:
075: The MLID cannot be registered with the LSL.
Source:
Possible Cause:
Action:
Possible Cause:
Action:
076: The polling procedure cannot be added.
Source:
Possible Cause:
Action:
NE1000-NW.LAN, NE2-NW.LAN, NE2000-NW.LAN, NE3200-NW.LAN
The server does not have enough available memory. NetWare cannot allocate
memory for the LAN driver.
Increase the memory available to the server. See
Temporarily in the Server Operating System Administration
NE1000-NW.LAN, NE2-NW.LAN, NE2000-NW.LAN, NE3200-NW.LAN
NetWare could not set the hardware interrupt that the LAN driver registered.
The LAN driver must have changed information in the configuration table
(IntNumber, SharingFlags) after the hardware options were registered.
Make sure the interrupt setting on the board matches the setting in the
AUTOEXEC.NCF file.
NE1000-NW.LAN, NE2-NW.LAN, NE2000-NW.LAN, NE3200-NW.LAN
The LAN driver's Link Support Layer (LSL) ran out of logical boards,
Unload nonessential LAN drivers that are consuming large numbers of logical
boards.
The LAN driver's Link Support Layer could not allocate memory for its
internal structures.
Increase the memory available to the server. See
Temporarily in the Server Operating System Administration
NE1000-NW.LAN, NE2-NW.LAN, NE2000-NW.LAN, NE3200-NW.LAN
Too many polling processes are registered with the operating system.
Unload nonessential NLM programs that are using a polling procedure.
Freeing Server Memory
Freeing Server Memory
Shared Messages for LAN Drivers 765
Guide.
Guide.