Novell NETWARE 6-DOCUMENTATION Manual page 3720

237: The adapter is beaconing.
Source:
Explanation:
Action:
239: The cable is disconnected at the board.
Source:
Explanation:
Action:
240: Cable is disconnected at the MAU.
Source:
Explanation:
Action:
241: The Auto Removal process reset the adapter.
Source:
Explanation:
Action:
241: The board's ROM has checksum errors.
Source:
Possible Cause:
Action:
CNTR2000.LAN
The ring has detected a network board that is trying to access the network with
an incorrect data rate.
Find out which network board in the ring is set at an incorrect data rate, and
correct it.
CNTR2000.LAN
The cable is disconnected from the network board.
Securely fasten the cable to the network board.
CNTR2000.LAN
The cable is disconnected from the Multistation Access Unit (MAU).
Securely fasten the cable into the MAU.
CNTR2000.LAN
The network board removed itself from the ring due to internal errors. The
driver will reset the network board and continue.
No action is required. If this condition occurs frequently, install another board
to see if it continues.
NE3200-NW, CNTR2000.LAN
The network board failed the self-test. A ROM checksum error occurred.
Check the network board and other hardware. If necessary, replace the
network board.
Shared Messages for LAN Drivers 769