Novell NETWARE 6-DOCUMENTATION Manual page 3710

007: You need another MLID section heading in the NET.CFG file in order to load the
MLID again.
Source:
Explanation:
Action:
008: A NET.CFG is required to load the MLID again.
Source:
Explanation:
Action:
009: The NET.CFG entry has been ignored.
Source:
Explanation:
Action:
011: The MLID does not support frame type. The protocol keyword has been ignored.
Source:
Explanation:
Action:
012: The protocol keyword must have a frame type. Entry ignored.
Source:
Explanation:
TRXNET-DOS.LAN
The driver cannot be loaded consecutively unless you edit the configuration
parameters and add a section heading for each instance in the NET.CFG file.
Unload the TRXNET driver. Edit/create the NET.CFG file and add a Link
Driver section heading for each time the driver is to be loaded; then reload the
driver.
TRXNET-DOS.LAN
The driver cannot be loaded unless you create a NET.CFG file. A Link Driver
section heading must be edited into the NET.CFG file for each time the driver
is to be loaded.
Unload the TRXNET driver. Edit and create the NET.CFG file and add a Link
Driver section heading for each time the driver is to be loaded.
TRXNET-DOS.LAN
The driver cannot be loaded consecutively unless you create a NET.CFG file
each time.
Unload the TRXNET driver. Edit/create the NET.CFG file and add a Link
Driver section heading for each time the driver is to be loaded.
TRXNET-DOS.LAN
An unsupported or incorrectly typed frame type has been specified with the
protocol keyword.
Check the contents of the NET.CFG file, and verify the frame type assigned
under the PROTOCOL keyword is valid.
TRXNET-DOS.LAN
The PROTOCOL keyword entry is incomplete.
Shared Messages for LAN Drivers 759