Novell NETWARE 6-DOCUMENTATION Manual page 3730

918: This utility was unable to get connection information. Error code: code.
Source:
Explanation:
Action:
919: This utility could not create a connection list. Error code.
Source:
Explanation:
Possible Cause:
Action:
920: This utility was unable to allocate number bytes of memory.
Source:
Possible Cause:
Action:
921: Either the supervisor has locked the bindery or volume SYS: is not mounted.
Source:
Possible Cause:
Action:
Possible Cause:
Action:
LOGIN.EXE, LOGOUT.EXE
For some unexpected reason, this utility was unable to obtain information
about a particular server.
Issue the command again from a different drive. For information about a
specific error code, search the
www.novell.com/documentation/lg/nwec/docui/index.htm).
LOGIN.EXE, LOGOUT.EXE, MAP.EXE, SETPASS.EXE
The utility failed in its attempt to create a list of all the connections to which
the workstation is currently attached.
The error code identifies a specific reason for the failure.
For information about a specific error code, search the
documentation (http://www.novell.com/documentation/lg/nwec/docui/
index.htm).
CX.EXE, LOGIN.EXE, LOGOUT.EXE, MAP.EXE, SETPASS.EXE
During its processing, the utility attempted to allocate more memory. No
additional memory was available, so the program was unable to allocate the
specified number of bytes.
Increase the memory available to the workstation. See
Workstation Memory Problems" on page
CAPTURE.EXE, LOGIN.EXE, MAP.EXE, SETPASS.EXE
The volume SYS: is not mounted.
Make sure that volume SYS: is mounted. (Type VOLUMES at the server
console to determine whether the volume SYS: has been mounted.)
The supervisor has locked the bindery.
If volume SYS: is mounted, make sure that the bindery is not closed.
Error Codes online documentation (http://
Common Workstation Utilities Error Messages 779
Error Codes online
"Resolving
787.