Novell NETWARE 6-DOCUMENTATION Manual page 3714

Action:
051: Board RAM failed the memory test.
Source:
Possible Cause:
Action:
054: The board did not respond to the initialization command.
Source:
Possible Cause:
Action:
065: Board cannot be found at slot/IO port. (Please check SLOT and PORT values in
the NET.CFG.)
Source:
Action:
Do one of the following:
Make sure the network board is properly seated into a slot.
Insert the network board into a slot, and run the Reference diskette to
install it.
NE1000-NW.LAN, NE2-NW.LAN, NE2000-NW.LAN, NE3200-NW.LAN
The memory test on the network board's internal static RAM failed.
Make sure the I/O port settings on the network board match the I/O port
settings in the AUTOEXEC.NCF file. If the settings match, replace the
network board.
NE1000-NW.LAN, TRXNET-DOS.LAN
The network board didn't respond to a reset command.
Make sure the I/O port settings on the network board match the I/O port
settings in the AUTOEXEC.NCF file. If the settings match, replace the
network board.
TRXNET-DOS.LAN
If you are using an ISA Bus network board, check the slot number and the I/
O address in the NET.CFG file.
If you are using a microchannel network board, do one or more of the
following:
Correct the slot number in the NET.CFG file to match the slot where the
network board is physically located.
Move the network board to the slot specified in the NET.CFG file; then
run the Reference diskette to install the network board.
Note: If no slot is specified in the NET.CFG file, the driver will search all slots
for the network board. If more than one network board is in the machine, the
slots must be specified in the NET.CFG file.
Shared Messages for LAN Drivers 763