Dscp (Rip View); Filter-Policy Export (Rip View) - HP 6125G Command Reference Manual

111.1.1.2
Total
Table 11 Command output
Field
Peer
Aging
Permanent
Garbage
Total

dscp (RIP view)

Syntax
dscp dscp-value
undo dscp
View
RIP view
Default level
2: System level
Parameters
dscp-value: Sets the Differentiated Services Code Point (DSCP) value for RIP packets, in the range of 0 to
63.
Description
Use dscp to set the DSCP value for RIP packets.
Use undo dscp to restore the default.
By default, the DSCP value in RIP packets is 48.
Examples
# Set the DSCP value for RIP packets of RIP process 1 to 63.
<Sysname> system-view
[Sysname] rip
[Sysname-rip-1] dscp 63

filter-policy export (RIP view)

Syntax
filter-policy { acl-number | ip-prefix ip-prefix-name } export [ protocol [ process-id ] | interface-type
interface-number ]
undo filter-policy export [ protocol [ process-id ] | interface-type interface-number ]
1 0
1 0
Description
IP address of a neighbor
Total number of aging routes learned from the specified neighbor
Total number of permanent routes learned from the specified neighbor
Total number of routes in Garbage-collection state learned from the specified neighbor
Total number of routes learned from all RIP neighbors
0
0
36