Chapter 1 Ntp Configuration Commands; Display Ntp-Service Sessions - 3Com 7750 Series Command Reference Manual

3Com Switch 7750 Series
Command Reference Guide – NTP

Chapter 1 NTP Configuration Commands

1.1 NTP Configuration Commands

1.1.1 display ntp-service sessions

Syntax
display ntp-service sessions [ verbose ]
View
Any view
Parameter
verbose: Displays the detailed information about all the sessions maintained by the
NTP service. When you configure this command without the verbose parameter, the
Ethernet switch displays the brief information about all the sessions.
Description
Use the display ntp-service sessions command to display the status of all the
sessions maintained by NTP service provided by the local device.
Caution:
The sessions can be created in all NTP operating modes except the NTP server
mode.
Example
# Display the status of all the sessions maintained by the NTP service.
<3Com> display ntp-service sessions
source
********************************************************************
[12345]1.0.1.11
note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured
reference stra reach poll now offset delay disper
LOCAL(0) 3 377
1-1
Chapter 1 NTP Configuration Commands
64 16 -0.4 0.0 0.9