930
C
55: NTP C
HAPTER
ONFIGURATION
display ntp-service
sessions
display ntp-service
status
C
OMMANDS
Use the undo debugging ntp-service command to disable corresponding
debugging function.
By default, no debugging function is enabled.
Example
# Enable NTP access control debugging.
<SW8800> debugging ntp-service access
Syntax
display ntp-service sessions [ verbose ]
View
Any view
Parameter
verbose: Specifies to display the detail information about the SESSIONS.
Description
Use the display ntp-service sessions command to display the status of all the
SESSIONS maintained by NTP service provided by the local equipment.
By default, the status of all the SESSIONS maintained by NTP service provided by
the local equipment will be displayed.
When you configure this command without the verbose argument, the switch
■
will display the brief information about all the SESSIONS it maintains.
With the verbose argument configured, the switch will display the detail
■
information about all the SESSIONS it maintains.
Example
# Display status of all SESSIONS maintained by the local device NTP service.
<SW8800> display ntp-service sessions
source
reference
stra reach poll
********************************************************************
[12345]127.127.1.0
LOCAL(0)
note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured
Syntax
display ntp-service status
View
Any view
Parameter
None
Description
Use the display ntp-service status command to display the NTP service status.
now offset
delay disper
7
377
64
16
0.0
0.0
0.9