Configuring The Attributes Of A Local User - 3Com 5500-EI PWR Install Manual

In string mode, if the VLAN ID assigned by the RADIUS server is a character string containing only
digits (for example, 1024), the switch first regards it as an integer VLAN ID: the switch transforms
the string to an integer value and judges if the value is in the valid VLAN ID range; if it is, the switch
adds the authenticated port to the VLAN with the integer value as the VLAN ID (VLAN 1024, for
example).
To implement dynamic VLAN assignment on a port where both MSTP and 802.1x are enabled, you
must set the MSTP port to an edge port.

Configuring the Attributes of a Local User

When local scheme is chosen as the AAA scheme, you should create local users on the switch and
configure the relevant attributes.
The local users are users set on the switch, with each user uniquely identified by a username. To make
a user who is requesting network service pass local authentication, you should add an entry in the local
user database on the switch for the user.
Follow these steps to configure the attributes of a local user:
2-7