Creating A Local User - 3Com 5500-SI Configuration Manual

418 C 21: 802.1
HAPTER

Creating a Local User

C
X ONFIGURATION
Network diagram
Figure 109 Network diagram for dynamic VLAN assignment
Supplicant Supplicant Supplicant Supplicant Supplicant Supplicant
Configuration procedure
1 Create a RADIUS scheme.
[S5500] radius scheme ias
[S5500-radius-ias] primary authentication 1.11.1.1
[S5500-radius-ias] primary accounting 1.11.1.1
[S5500-radius-ias] key authentication hello
[S5500-radius-ias] key accounting hello
[S5500-radius-ias] quit
2 Create an ISP domain and reference the created RADIUS scheme in the domain.
[S5500] domain ias
[S5500-isp-ias] radius-scheme ias
3 Configure the VLAN assignment mode to string and return to the system view.
[S5500-isp-ias] vlan-assignment-mode string
[S5500-isp-ias] quit
4 Create a VLAN and specify a name for the VLAN.
[S5500] vlan 100
5 Set the name of the assigned VLAN to test.
[S5500-vlan100] name test
A local user is a group of users set on NAS. The user name is the unique identifier of a
user. A user requesting network service may use local authentication only if its
corresponding local user has been added onto NAS.
Perform the following configurations in System View
Table 446 Creating/Deleting a Local User and Relevant Properties
Operation
Add local users
Delete all the local users
Delete a local user by specifying
its type
By default, there is no local user in the system.
RADIUS authentication servers RADIUS authentication servers
IP address: 1.11.1.1 IP address: 1.11.1.1
Switch Switch Switch Switch Switch Switch Switch
Ethernet0/1 Ethernet0/1
Authenticator Authenticator Authenticator
Command
local-user user_name
undo local-user all
undo local-user { user_name | all [
service-type { lan_access | ftp | telnet | ssh
| terminal } ] }
Internet Internet Internet Internet Internet Internet Internet