Pim Configuration Examples - 3Com Switch 4800G 24-Port Configuration Manual

PIM Configuration
Examples
PIM-DM Configuration
Example
Network requirements
Receivers receive VOD information through multicast. The receiver groups of
■
different organizations form stub networks, and one or more receiver hosts
exist in each stub network. The entire PIM domain operates in the dense mode.
Host A and Host C are multicast receivers in two stub networks.
■
Switch D connects to the network that comprises the multicast source (Source)
■
through VLAN-interface 300.
Switch A connects to stub network N1 through VLAN-interface 100, and to
■
Switch D through VLAN-interface 103.
Switch B and Switch C connect to stub network N2 through their respective
■
VLAN-interface 200, and to Switch D through VLAN-interface 101 and
VLAN-interface 102 respectively.
IGMPv2 is to run between Switch A and N1, and between Switch B/Switch C
■
and N2.
Network diagram
Figure 196 Network diagram for PIM-DM configuration
Vlan-int300
Source
Switch D
10.110 .5.100 /24
Device Interface
Switch A Vlan-int100
Vlan-int103
Switch B Vlan-int200
Vlan-int101
Switch A
Vlan -int100
Vlan -int101
Vlan -int101
Switch B
Vlan -int200
PIM-DM
Switch C
IP address Device
10.110.1.1/24 Switch D
192.168.1.1/24
10.110.2.1/24
192.168.2.1/24

PIM Configuration Examples

Receiver
Host A
Host B
Receiver
Vlan -int200
Host C
Host D
Interface IP address
Vlan-int300 10.110.5.1/24
Vlan-int103 192.168.1.2/24
Vlan-int101 192.168.2.2/24
Vlan-int102 192.168.3.2/24
659