Accessing Configuration Commands; Management Console Commands - 3Com 3C780 - LinkBuilder FDDI Base Unit User Manual

3-8 Configuring the Hub
You can operate the hub using its default configuration without making any
changes whatsoever. However, you may want to change various parameters to
suit your particular network environment. Refer to Chapters 4 and 5 and
Appendix C for information about making changes to the hub's default
configuration.
If you should want to return the hub to its default configuration (after making
changes), use the set defaults command, which is accessible only in the
primitive command mode.

Accessing Configuration Commands

You can configure the hub using the commands in two command modes:

Management Console Commands

Management console commands allow you to:
You can access the management console command mode by doing one of the
following:
Management console commands
Primitive console commands
Display current parameter settings and configuration information
Set or change certain configuration-related parameters
Display a list and descriptions of the command set
Invoke several TCP/IP network troubleshooting commands
Attaching a terminal to the RS-232 serial port on the management module
Connecting a Hayes-compatible modem to the RS-232 serial port on the
management module
Using the TCP Telnet protocol over the network