Table of Contents
Advertisement
50
C
3: A
HAPTER
CCESSING THE
IP Host
Configuration
Commands
Table 12 IP Host Configuration Commands
Command
config iparp add <ipaddress>
<mac_address>
config iparp delete <ipaddress>
config iparp timeout <minutes>
clear iparp {<ipaddress> | vlan <name>} Removes dynamic entries in the IP ARP table.
config iproute add default <gateway>
{<metric>}
config iproute delete default <gateway> Deletes a default gateway from the routing
show iparp {<ipaddress> | vlan <name> |
permanent}
show iproute {vlan <name> | <ipaddress>
<mask>}
Using the Web
Interface
S
WITCH
Table 12
describes the commands that are used to configure IP settings
on the switch.
The Web Interface is device-management software running in the switch
that enables you to access the switch over a TCP/IP network using a
standard Web browser. Any properly configured standard Web browser
that supports frames (such as Netscape Navigator 3.0 or Microsoft
Internet Explorer 3.0) can manage the switch over a TCP/IP network.
For more information on assigning an IP address, refer to the section,
"Configuring Switch IP Parameters,"
Description
Adds a permanent entry to the Address
Resolution Protocol (ARP) table. Specify the IP
address and MAC address of the entry.
Deletes an entry from the ARP table. Specify
the IP address of the entry.
Configures the IP ARP timeout period. The
default setting is 20 minutes. A setting of 0
disables ARP aging.
Permanent IP ARP entries are not affected.
Adds a default gateway to the routing table.
A default gateway must be located on a
configured IP interface. If no metric is
specified, the default metric of one is used.
table.
Displays the IP ARP table. You can filter the
display by IP address, VLAN, or permanent
entries.
Displays the contents of the IP routing table.
on
page
46.
Advertisement
Table of Contents
