To do...
Display the statistics on the
routing table
Clear statistics about a
routing table
Delete all static routes
Static Route Configuration Example
Basic Static Route Configuration Example
Network requirements
The IP addresses and masks of the switches and hosts are shown in the following figure. Static routes
are required for interconnection between any two hosts.
Figure 1-2 Network diagram for static route configuration
Configuration procedure
1)
Configuring IP addresses for interfaces (omitted)
2)
Configuring static routes
# Configure a default route on Switch A.
<SwitchA> system-view
[SwitchA] ip route-static 0.0.0.0 0.0.0.0 1.1.4.2
# Configure two static routes on Switch B.
<SwitchB> system-view
[SwitchB] ip route-static 1.1.2.0 255.255.255.0 1.1.4.1
[SwitchB] ip route-static 1.1.3.0 255.255.255.0 1.1.5.6
# Configure a default route on Switch C
<SwitchC> system-view
[SwitchC] ip route-static 0.0.0.0 0.0.0.0 1.1.5.5
3)
Configure the hosts.
Use the command...
display ip routing-table statistics
reset ip routing-table statistics
protocol { all | protocol }
delete static-routes all
1-4
Remarks
Use the reset command in
user view
Use the delete command in
system view.