Auerswald COMpact 5200 Advanced Information page 328

Hide thumbs Also See for COMpact 5200:

Table of Contents

Initiating Query Call to Third Subscriber

4. Proceed as required.

To disconnect the third call and go back to the query call with the

previously active communication partner, press the Flash key or

the Query key and dial 1.

•You then make a query call with the communication partner who

had previously been active. The call with the third communication

partner is disconnected.

To disconnect the third call and go back to the query call with the

communication partner who had previously been on hold, press

the Flash key or the Query key and dial 2.

•You will then make a query call with the communication

partner who had previously been on hold. The call with the third

communication partner is disconnected.

To disconnect the previous calls and make an one-on-one call with

the third communication partner, press the Flash key or the Query

key and dial 0.

•You are making an one-on-one call with the third communication

partner. The previous calls have been disconnected.

To connect the third communication partner to the second

communication partner, press the Flash key or the Query key and

•The second and the third communication partner are now

connected with each other. They are making an one-on-one call

with the first communication partner.

Note: If the third communication partner goes off-hook beforehand,

you will get back to the previously active communication partner.

COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019

Need help?

Do you have a question about the COMpact 5200 and is the answer not in the manual?

Compact 5200r Compact 5500r