Configuring Isdn System Phones Remotely Via The External S 0 Port On The Pbx (Externally) - Auerswald COMpact 5200 Advanced Information

Configuring ISDN System Phones Remotely via the External S 0 Port on the PBX (Externally)

Configuring ISDN System Phones Remotely via the
External S
0
Requirements:
• PBX with internal ISDN system phones
• In the PBX configured remote switching number for system phones
and dealer access number (page Administration > Remote
configuration)
Note: If no dealer access number has been configured or the phone
number transmitted does not correspond with the configured phone
numbers, the PBX must be enabled via an internal phone using a digit
sequence for remote configuration.
• An existing external ISDN connection between the PC and the PBX
including the drivers
• Installed COMfortel Set configuration software version 3.0, or later
• Knowledge of the user, sub-admin or admin PIN
• Activation of the PBX immediately before remote configuration (see
section Short Reference) if no dealer access number has been
configured or the transmission of the configured numbers is not
possible on the computer being used
1. Start COMfortel Set.
2. Open Options > Interface....
3. Under Interface, select ISDN card (CAPI 2.0).
COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019
Port on the PBX (Externally)
- 80 -