Initiating External Callback On No Response - Auerswald COMpact 5200 Advanced Information

Initiating External Callback on No Response

Initiating External Callback on No Response
If you initiated a callback, you call the subscriber you did not reach
previously as soon as he is available again.
Requirements:
• Service feature CCNR (callback on no response) is enabled by the
network provider.
• Use of an external S
the Instructions)
Important: On system phones, this function is called via the menu/
phone app (optional, see manual for the phone).
Note: To use this function at ISDN phones or to delete it again, this
function must be supported via a function key or via the menu by the
respective phone (optional, see manual for the phone).
Note: Some analogue phones permit this function via the T-Net
function key/menu (optional, see manual for the phone).
If the subscriber does not answer your call proceed as follows:
1. Press the Flash key or the Query key.
2. Dial *37#.
Note: If you do not hear a confirmation tone, the callback request was
not successful.
COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019
port for the call (optional, see Technical Data in
0
- 316 -