Auerswald COMpact 5200 Advanced Information page 594

Settings PBX Base Number/Bundle
Note: you can enter a zero both as a single number (e.g. 0 to 99, as
is usually the case) and as a digit in the set number of places in extension
numbers (e.g. 00 to 99).
Note: If linear call distribution for the PTP connection is enabled
(Réseaux publics > Acheminement des appels page), and if the
internal numbers match the external extension numbers, the system
automatically performs a 1:1 assignment for the extension numbers in
the extensions block. If an extension cannot be assigned, the fallback call
distribution function is enabled.
Note: If you want an extension number to be different from the ones
used in linear call distribution, or if an extension number is needed for a
different function (e.g. remote configuration, CLIP no screening), you must
also enter it in the phone number list (page Réseaux publics > RNIS >
Numéros Directs (SDA) en PTP).
Note: For example, for extensions block 0 to 99: enter extension 0 as
an extension and assign it in the call distribution.
Note: For example, for extensions block 00 to 99: enter the individual
extension numbers 00 to 09 as an extension number and assign them
during call distribution. The PBX will then only react when the number
of places is reached, for example, if the caller dials 00 as an extension
number. In contrast, if the caller only dials 0, the fallback call distribution
function is enabled as soon as the time for selecting a suffix dialling digit
has passed.
COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019
- 594 -