Tones - Auerswald COMpact 5200 Advanced Information

Hide thumbs Also See for COMpact 5200:

Table of Contents

Tones

Proceed as follows:

Separately for analogue ports

Using the Configuration Manager (page Réseaux publics >

Analogique > Numéros de téléphone > Configurer)

Requirements:

External analogue port (optional, see Technical Data in the

Instructions)

Connexion analogique

Select the analogue connection to be displayed/configured.

The character strings show which tones are sent by the analogue network

provider. This means the PBX can then identify the tones and apply them

accordingly.

The network provider uses these tones in the following situations:

When a subscriber picks up the call.

If the required connection is busy (busy signal 1), or if the network

is overloaded (busy signal 2, e.g. directly after dialling the local area

Tonalité d'appel

During the call phase.

Tonalité d'intérêt spéciale

COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019

Compact 5200r Compact 5500r