Configuring Loudspeaker Announcements - Auerswald COMpact 5200 Advanced Information

Configuring Loudspeaker Announcements

Configuring Loudspeaker Announcements
Proceed as follows:
Using the Configuration Manager (page Périphériques > Assistant
•
de périphériques > Configurer)
In order to make loudspeaker announcements, a device that can be used
as announcement output (e. g. an a/b-Audiobox at a loudspeaker system)
must be connected to the PBX. This announcement output must be
created in the configuration of the PBX and assigned an internal number
to call it.
The announcement output can be created with the device wizard. Various
devices supported by the PBX that can be used as announcement output
are available as device templates for this purpose. Their factory settings
already include several default values for operation of the announcement
outputs.
If no of the device templates on offer matches your installation, you can
select a user-defined device template.
If you use the announcement output of a COMmander 2TSM (R) module,
the announcement output is created when configuring the module (see
2TSM Module).
Numéro de téléphone
This is an internal number. You can select any of the numbers in the
internal supply of phone numbers. This number can be called directly by
an internal subscriber. (Entry on page Périphériques > Assistant de
périphériques)
Note: A number cannot be allocated twice.
COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019
- 894 -