Accepting An Alarm Call And Confirming The Alarm - Auerswald COMpact 5200 Advanced Information

Hide thumbs Also See for COMpact 5200:

Table of Contents

Accepting an Alarm Call and Confirming the Alarm

An alarm can be signalled by the ringing of an internal or external phone.

To terminate the alarm loop and to switch off assigned relays, the alarm

can be confirmed.

Proceed as follows:

Using an internal or external phone

Requirements:

DTMF-capable phone or DTMF dialler

If an alarm is signaled at an internal or external phone, proceed as follows:

1. Pick-up the receiver.

You will hear the announcement.

2. Within the next 60 seconds dial 0.

You will hear the confirmation tone.

Note: You can confirm the alarm already during the announcement. If

you do not confirm the alarm (or dial a wrong digit), you will hear the busy

signal and the call will be automatically terminated by the PBX. A further

alarm call may be initiated after some time if the other alarm subscribers

do not confirm the alarm.

COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019

Compact 5200r Compact 5500r