Auerswald COMpact 5200 Advanced Information page 938

Loudspeaker Announcements
Note: The switching duration is used for relays with the operating
modes Light, Door opener, Alarm, PC relay and Manual relay.
Note: To enable the PBX to switch off the relay after the specified
switching duration, off control must be supported by the relay and be
switched on (for some relays, e. g. the a/b Switching Modules, switching
off cannot be controlled). Alternatively, the hold time of the relay can be
used.
Délai de rétention
If switching off is not to be controlled by the PBx (for some relays, e. g. the
a/b Switching Modules, switching off cannot be controlled), the hold time
of the relay can be used instead of the switching duration. This will only
make sense if the hold time of the relay is sufficiently long, for example for
a door opener.
The PBX needs to know how long the relay will be held in order to
signalise holding of the relay on the system phones (see the manual of the
device in question).
Requirements:
• Created relay
• Off control switched on for the relay
Enter the hold time of the relay in milliseconds. Possible entries: 10 to
10000 ms.
Relais déclenchable par URL d'action
Provided that the access authorisation to Action URLs is granted system-
wide or for a subscriber, the individual relay can be triggered by Action
URLs.
COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019
- 938 -