Auerswald COMpact 5200 Advanced Information page 630

SIP
Note: When the SIP session timer is switched on, this may result in
the call being interrupted more frequently after the specified interval, if a
VoIP provider has not implemented session renewal properly. In this case,
you should adjust the interval of the SIP session timer or switch it off.
Désactivation de SIP Prack (RFC 3262)
The negotiation of SIP option „100rel" is disabled. This might be
necessary if the provider supports „SIP-Forking".
Numérotation en bloc uniquement Delay time after last digit dialled
(3 to 15 sec.)
A connection is not set up to transmit the digits dialled here to the provider
until the delay time after the last digit is dialled has passed. All the digits
are then sent as a block. Time measurement restarts after the entry of
each digit. After the selected time has passed, the PBX recognises the
most recent digit as the final digit and will not allow any more numbers to
be entered.
Note: En-bloc dialling is a good idea, for example, when dialling single
digits causes problems in sub-system operation.
Note: Select as short a time as possible, because the PBX does not
forward the entire phone number to the public exchange until the specified
time has passed.
Note: Approximately three seconds is the default value for manual
inputs.
COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019
- 630 -