Auerswald COMpact 5200 Advanced Information page 555

Start of Call (Outgoing Calls)
Note: Approximately three seconds is the default value for manual
inputs.
Note: You can always press # (the hash key) when you finish
dialling the phone number to keep the waiting time between dialling the
last number and the connection being set up to a minimum. The PBX
recognises this character as the end of the phone number.
Transmit #
The PBX transmits the # (hash key) character, appended to the number
you are dialling, used to signal that you have finished, to the public
exchange.
Reconnaissance de la tonalité occupée
The PBX recognises the busy signal sent by the public exchange
(recommended setting).
This is needed to allow the CCBS (callback when busy) function to be
enabled using the PBX's internal phones.
Max. hold time until audio connection established (0-30 seconds)
The time to wait until the audio connection is created specifies the
maximum time, in seconds, that the PBX will wait for the connection
information sent by the public exchange. If the PBX does not receive a
busy signal, a continuous tone or a polarity reversal of the line after this
time has passed, it creates the connection.
The PBX also creates the connection if it detects a call tone, and then a
voice, even before the waiting time has passed.
COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019
- 555 -