Configuring Internal Ip Telephony - Auerswald COMpact 5200 Advanced Information

Hide thumbs Also See for COMpact 5200:

Table of Contents

Configuring Internal IP Telephony

Requirements:

Internal VoIP channel (optional, see Technical Data in the Instructions)

Proceed as follows:

1. Configure a VoIP channel as an internal VoIP channel for each

planned internal VoIP subscriber.

2. If necessary, configure the Port SIP du registre VoIP interne.

3. Create internal numbers for the VoIP subscribers.

4. If required, change the automatically generated PINs and passwords.

Note: The user passwords are needed to authenticate the VoIP

phones when they are registered with the PBX.

5. Configure the VoIP end devices. To do this, you need the following

information:

IP address or URL of the PBX

SIP port of the internal VoIP registrar

Internal number of the VoIP subscriber

User password of the VoIP subscriber

Note: You will find notes about how to configure different VoIP end

devices on the Internet (see

6. Check whether the VoIP subscriber was successfully registered on the

PBX (page Surveillance > Status int. VoIP subscribers).

COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019

Auerswald Service

Compact 5200r Compact 5500r