Settings Announcement Output - Auerswald COMpact 5200 Advanced Information

Hide thumbs Also See for COMpact 5200:

Table of Contents

Settings Announcement Output

Proceed as follows:

Separately for announcement outputs

Using the Configuration Manager (page Périphériques > Interfaces

de paging > Configurer)

Requirements:

Created announcement output

Configuration de l'interface de paging

Select the announcement output you want to configure.

Activer la connexion

Terminer la connexion

Specifies which DTMF sequences the PBX uses to control the analogue

announcement outputs to enable or terminate the connection. For

information about which DTMF sequences the connected device requires,

see the manual of the device in question.

Note: You can use the comma ',' character as a pause of half a

Specifies how many milliseconds the PBX will wait before it sends DTMF

sequences to the announcement output again. For information about

how much time the connected device requires to be ready for reception

COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019

Do you have a question about the COMpact 5200 and is the answer not in the manual?

Compact 5200r Compact 5500r