Recording The D-Channel Protocol - Auerswald COMpact 5200 Advanced Information

Hide thumbs Also See for COMpact 5200:

Table of Contents

Recording the D-Channel Protocol

A D-channel protocol can be started to record and display control and

management information about the connections to the PBX e.g. to display

errors. You will thus be able to see the error type, and maybe even its

cause, from the list of transferred information.

Proceed as follows:

Using the D-channel decoder PC programme

Requirements:

D-channel decoder PC programme installed (see Auerswald:

Auerswald Service

Logging enabled function switched on in the PBX

D-channel option selected in the PBX

1. Start the D-channel decoder computer programme.

2. Click Démarrer.

3. In the Interface list field, select the IP option.

4. Enter the IPv4 address or, as of decoder version 2.6.7, the IPv6

address of the PBX in the Adresse IP entry field.

Note: If a port is present, omit it when you enter the IP address.

5. Click Ok.

The protocol log is displayed.

COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019

Portal, FONtevo: FONtevo)

Do you have a question about the COMpact 5200 and is the answer not in the manual?

Compact 5200r Compact 5500r