Routage - Auerswald COMpact 5200 Advanced Information

Routage

Routage
Important: The expert settings for the ISDN connection are
settings that should only be changed if e. g. country or provider-specific
particularities make it absolutely necessary.
Proceed as follows:
• Using the Configuration Manager (page Réseaux publics > RNIS >
Liasion Point-Multi-Point (PMP) > Paramètres expert > Configurer)
Requirements:
• Configured PTMP connection
Utiliser Soft-LCR 4.0 pour ce raccordement
Requirements:
• Network provider must support the dial-around service
• Configured prefixes (country prefix and local area code)
• Configured LCR (see LCR)
The ISDN connection is used for LCR calls.
Note: LCR must be disabled if the network provider does not support
LCR.
Note: However, you can always perform LCR manually by dialling a
provider area code prefix if the network provider supports the dial-around
service.
COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019
- 579 -