Auerswald COMpact 5200 Advanced Information page 759

Analogue Settings
• Subscriber is an analogue end device
Infos CLIP
Requirements:
• Subscriber is a CLIP-capable analogue phone
The phone number information (if transmitted) is displayed on the display
of the phone.
Infos CLIP étendues
Requirements:
• Subscriber is a CLIP-capable analogue phone
In the caller list of the phone date and time of missed calls are recorded.
The name can be displayed instead of or in addition to the phone number.
Note: For some end devices, extended CLIP information can cause
problems and should therefore be disabled.
Durée du flashing (décrocher-raccrocher)
Hook flash timing enables the PBX to detect a flash signal from the
subscriber in question.
For this to work, the hook flash timing must correspond with the time that
is configured for the flash signal on the analogue end device (see the
phone manual).
Note: DTMF phones that execute various functions using the T-Net
function key/menu use a flash of 300 ms to do this. In order to also use
these functions on the PBX, the same time as the hook flash timing must
be configured on the PBX. Usually, there is an additional flash button
COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019
- 759 -