Initiating Internal Callback On No Response - Auerswald COMpact 5200 Advanced Information

Hide thumbs Also See for COMpact 5200:

Table of Contents

Initiating Internal Callback on No Response

If you initiated a callback, you call the subscriber you did not reach

previously as soon as he is available again.

Important: On the system phones, this function is called via the menu/

phone app (optional, see manual for the phone).

Important: To use this function at ISDN phones or to delete it again,

this function must be supported via a function key or via the menu by the

respective phone (optional, see manual for the phone).

Note: Some analogue phones permit this function via the T-Net

function key/menu (optional, see manual for the phone).

If the subscriber does not answer your call proceed as follows:

1. Press the Flash key or the Query key.

2. Dial *37#.

3. Hang up the receiver. You are called as soon as the subscriber is

4. Pick up the receiver to the make the callback. If you do not pick up

within 20 seconds, the callback is deleted.

COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019

Compact 5200r Compact 5500r