Configurig Ip Switch Relays - Auerswald COMpact 5200 Advanced Information

Configurig IP Switch Relays

Configurig IP Switch Relays
Proceed as follows:
Using the Configuration Manager (page Périphériques > Assistant
•
de périphériques > Configurer)
An existing IP switch relay can be connected to the PBX so that various
functions controled by the PBX (see
carried out. This IP switch relay must be created in the configuration of the
PBX.
The IP switch relay and the relays available for it can be created with
the device wizard. To control the relays, the PBX needs to know the IP
address, port, user name (optional) and password of the connected device
(see manual and settings of the device in question).
Various IP switch relays supported by the PBX are available as device
templates. They already include several default values for operation of the
IP switch relays in their factory settings.
If no of the device templates on offer matches your installation, you can
select a user-defined device template.
In addition, you can select a simplified device template (IPBox Simple)
which will make it easier for you to create an IP switch relay with the
operating mode Relais manuel.
Configuration IP
Adresse IP
Enter the IP address required by the connected device. Possible entries:
IP address with a range of 0 to 255 (example: 192.168.0.240).
Port
Enter the port required by the connected device. Possible entries: 1 to
65535.
COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019
Relay Operating
- 892 -
Modes) can be