Door Terminals - Auerswald COMpact 5200 Advanced Information

Door Terminals

Door Terminals
Proceed as follows:
Using the Configuration Manager (page Périphériques > Assistant
•
de périphériques > Configurer)
An existing door terminal can be connected to the PBX so that various
door functions such as speech connection with the door and actuation
of the door opener from internal phones can be carried out. This door
terminal must be created in the configuration of the PBX and allocated an
internal number where it can be called.
The door terminal and the relays and switch inputs (door bell buttons)
available for it can be created with the device wizard. Door calls can
be created for the switch inputs of the door terminal by selecting call
destinations. To detect their actuation e. g. because a door bell button has
been pressed, the PBX needs to know which DTMF sequence or which
SIP invite the door terminal sends when a button is pressed (see manual
and settings of the device in question).
Note: The DTMF sequence or the SIP invite usually is the phone
number assigned to the door bell button within the door terminal.
Note: After the door terminal has been configured in the PBX, the
complete door call distribution will be controlled by the PBX – with
regard to the call destinations as well as with regard to the maximum call
duration.
Note: The door call distribution can be set to depend on the
configuration – differently for night and day, for example.
Only for VoIP door terminals: To create a connection with a VoIP door
terminal, the PBX needs to know the SIP password of the connected
COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019
- 886 -