Transferring With Announcement - Auerswald COMpact 5200 Advanced Information

Transferring with Announcement

Transferring with Announcement
In order to transfer a call, first initiate a query call, announce the call and
then connect both communication partners.
Requirements:
• Initiated query call
• To connect two external communication partners, the following is
required: Authorisation Transfert d'appels externes vers l'extérieur
assigned to the subscriber
• Hang up the receiver during a query call.
Both communication partners are connected with each other.
Note: Some ISDN phones may ring after hanging up the receiver and
you may then be reconnected with your first communication partner after
picking up the receiver. Use the manual for the phone to check whether
the Transfer at a PBX function has been enabled. If this has not been
done, do this subsequently.
• If you want to initiate a new call immediately after the transfer, proceed
during the query call as follows.
Both communication partners are connected with each other.
You will hear the internal dial tone.
Important: A call transferred between two external communication
partners is limited to a defined period of time. This is a security feature,
since the transfer of the time announcement or of the weather forecast
made by mistake, for instance, would lead to a very long call.
COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019
- 331 -