Action Url (Http Request) - Auerswald COMpact 5200 Advanced Information

Hide thumbs Also See for COMpact 5200:

Table of Contents

Action URL (HTTP Request)

An Action URL is a function that can send requests via a link to a certain

device. The device that receives the Action URL subsequently performs

this request. The request and the IP address/URL of the Action URL

receiving device is entered directly into the Action URL.

Note: Currently, Action URLs in the PBX can only be sent if an alarm

was configured and is triggered. However, in this way, all requests can be

sent that the Action URL receiving device recognizes.

Note: A maximum of 32 Action URLs can be configured.

The sequence can be as follows:

Alarm detection via a switch input or a call to the alarm phone number.

The set alarm delay time is running (0-99 seconds).

The first alarm call run starts with the call of the first alarm subscriber.

At the same time, the Action URL is sent (Alarm type start). If an alarm

subscriber acknowledges the alarm, the alarm will be ended. At the

same time, an Action URL is sent (Alarm type acknowlegded). If the

alarm is not acknowlegded, it ends after all alarm loops. At the same

time, an Action URL is send (Alarm type timeout).

Proceed as follows for configuration:

Configuring Action URLs for a device.

Using the Configuration Manager (page Périphériques > URL

Linking an Action URL with an alarm.

COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019

Compact 5200r Compact 5500r