End Of The Call - Auerswald COMpact 5200 Advanced Information

Hide thumbs Also See for COMpact 5200:

Table of Contents

End of the Call

Proceed as follows:

Separately for analogue ports

Using the Configuration Manager (page Réseaux publics >

Analogique > Numéros de téléphone > Configurer)

Requirements:

External analogue port (optional, see Technical Data in the

Instructions)

ANALOGER ANSCHLUSS

Auswahl des analogen Anschlusses, der angezeigt/eingerichtet werden

Reconnaissance de la tonalité occupée (appels entrants)

Reconnaissance de la tonalité occupée (appels sortants)

The PBX recognises the busy signal sent by the public exchange.

It needs this to identify that the call connection has finished and to

automatically disconnect an ISDN phone.

Note: Disable this setting if the PBX identifies disruptions on the

external line as the busy signal, because this would cause it to interrupt

conversations. In this situation, the subscriber must signal to the PBX that

the call is ended by disconnecting.

Longueur minimale de la tonalité occupée (3-20 secondes)

COMpact 5200/5200R/5500R - Firmware V7.4A - Advanced Information V08 06/2019

Compact 5200r Compact 5500r