Sending The Information To Snmp Network Management - Huawei Quidway S6500 Series Operation Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches
may have different default settings of log, trap and debugging. When there is no
specific configuration record for a module in the channel, use the default one.
Note:
If you want to view the debugging information of some modules on the switch, you must
select debugging as the information type when configuring information source,
meantime using the debugging command to turn on the debugging switch of those
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in system view:
Table 4-41 Configuring the output format of time-stamp
Configure the output format of the
time-stamp
Output time-stamp is disabled

4.5.8 Sending the Information to SNMP Network Management

To send configuration information to SNMP NM, follow the steps below:
1) Enabling info-center
Perform the following operation in system view.
Table 4-42 Enabling/disabling info-center
Enable info-center
Disable info-center
Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
Operation
Operation
Huawei Technologies Proprietary
4-25
Chapter 4 System Maintenance and Debugging
Command
info-center timestamp
debugging } { boot | date | none }
undo info-center timestamp { log | trap |
debugging }
info-center enable
undo info-center enable
{ log | trap
Command
|