Table of Contents
Advertisement
ATN 950B Multi-service Access Equipment
Hardware Description
Figure 9-6 Appearance of the PGND cable
Table 9-2 Technical specifications of the power cable and PGND cable
Wire Related Parameter
Electronic/Electric wire, 450 V/750 V, H07Z,
K, 4 mm
resistant cable with low smoke and no
halogen
9.2 Management Cables
On the ATN 950B, Ethernet cables are used to input and output NM signals.
The management cables for the ATN 950B include Ethernet cables.
Ethernet cables are classified into straight-through cables and crossover cables, and are used for
communication between the equipment and the NMS computer. The NM interface on the
equipment is adaptive to a straight-through cable or a crossover cable.
Figure 9-7
When the cable is connected to the ETH/OAM interface, the pin assignment of the RJ45
connector is as listed in
Table 9-4
Figure 9-7 RJ45 connector
PIN#1
Issue 03 (2012-07-23)
2
2
(0.006 in.
), yellow green, fire
shows an RJ45 connector used at the end of the Ethernet cable.
Table
lists the technical specifications of the Ethernet cable.
PIN#8
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Terminal Related Parameter
General terminal, OT, 6 mm
plating, pre-insulated ring terminal,
12-10AWG, yellow
9-3.
9 Cables
2
2
(0.009 in.
), tin
94
Advertisement
Table of Contents
