Huawei Quidway S6500 Series Operation Manual page 152

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
View the routing information found by
the specified protocol
View the tree routing table
View the statistics of the routing table
2.4 Typical Static Route Configuration Example
I. Networking requirements
As shown in the figure below, the masks of all the IP addresses in the figure are
255.255.255.0. It is required that all the hosts or S6500 Series Ethernet Switches can
be interconnected in pairs by configuring static routes.
II. Networking diagram
1.1.1.1/24
C
Host 1.1.1.2/24
Figure 2-1 Networking diagram of the static route configuration example
III. Configuration procedure
# Configure the static route for Ethernet Switch A
[Switch A] ip route-static 1.1.3.0 255.255.255.0 1.1.2.2
[Switch A] ip route-static 1.1.4.0 255.255.255.0 1.1.2.2
[Switch A] ip route-static 1.1.5.0 255.255.255.0 1.1.2.2
# Configure the static route for Ethernet Switch B
[Switch B] ip route-static 1.1.2.0 255.255.255.0 1.1.3.1
Operation
Host 1.1.5.2/24
A
1.1.5.1/24
1.1.2.2/24
1.1.3.1/24
Switch C
1.1.2.1/24
Switch A
Switch B
Huawei Technologies Proprietary
2-5
Chapter 2 Static Route Configuration
display ip
protocol [ inactive | verbose ]
display ip routing-table radix
display ip routing-table statistics
1.1.3.2/24
1.1.4.1/24
B
Host 1.1.4.2/24
Command
routing-table protocol