Huawei Quidway S6500 Series Operation Manual page 45

Operation Manual - Port
Quidway S6500 Series Ethernet Switches
Table 1-3 Set description character string for Ethernet port
Set description character string for Ethernet port.
Delete the description character string of Ethernet.
By default, the port description is a null character string.
1.2.4 Set Duplex Attribute of the Ethernet Port
To configure a port to send and receive data packets at the same time, set it to
full-duplex. To configure a port to either send or receive data packets at a time, set it to
half-duplex. If the port has been set to auto-negotiation mode, the local and peer ports
will automatically negotiate about the duplex mode.
Perform the following configuration in Ethernet port view.
Table 1-4 Set duplex attribute for Ethernet port
Set duplex attribute for Ethernet port.
Restore the default duplex attribute of Ethernet port.
Note that, 100M electrical Ethernet port can operate in full-duplex, half-duplex or
auto-negotiation mode. The Gigabit electrical Ethernet port can operate in full duplex,
half duplex or auto-negotiation mode. When the port operates at 1000Mbps, the duplex
mode can be set to full (full duplex) or auto (auto-negotiation). The optical
100M/Gigabit/10Gigabit Ethernet ports support full duplex mode and can be configured
to operate in full (full duplex) or auto (auto-negotiation) mode.
The port defaults the auto (auto-negotiation) mode.
1.2.5 Set Speed on the Ethernet Port
You can use the following command to set the speed on the Ethernet port. If the speed
is set to auto-negotiation mode, the local and peer ports will automatically negotiate
about the port speed.
Perform the following configuration in Ethernet port view.
Operation
Operation
Huawei Technologies Proprietary
1-3
Chapter 1 Ethernet Port Configuration
Command
description text
undo description
Command
duplex { auto | full | half }
undo duplex