Huawei Quidway S6500 Series Operation Manual page 73

Operation Manual - VLAN
Quidway S6500 Series Ethernet Switches
Perform the following configuration in VLAN interface view.
Table 1-7 Shut down/Enable VLAN interface
Shut down the VLAN interface
Enabling the VLAN interface
The operation of shutting down or enabling the VLAN interface has no effect on the
UP/DOWN status of the Ethernet ports on the local VLAN.
By default, when all the Ethernet ports belonging to a VLAN are in DOWN status, this
VLAN interface is also DOWN, i.e. this VLAN interface is shut down. When there is one
or more Ethernet ports in UP status, this VLAN interface is also UP, i.e. this VLAN
interface is enabled.
1.3 Port-Based VLAN Configuration
1.3.1 Add Ethernet Ports to a VLAN
You can use the following command to add the Ethernet ports to a VLAN.
Perform the following configuration in VLAN view.
Table 1-8 Add Ethernet ports to a VLAN
Add Ethernet ports to a VLAN
Remove Ethernet ports from a VLAN
By default, the system adds all the ports to a default VLAN, whose ID is 1.
Note that you can add/delete trunk port and hybrid port to/from VLAN by port trunk
permit vlan, undo port trunk permit vlan, port hybrid vlan, undo port hybrid vlan
commands in Ethernet port view, but not in VLAN view.
1.4 Protocol-Based VLAN Configuration
You can divide VLAN based on encapsulation formats and network layer protocols such
as AppleTalk, IP, and IPX.
Operation
Operation
Huawei Technologies Proprietary
1-5
Chapter 1 VLAN Configuration
Command
shutdown
undo shutdown
Command
port interface-list
undo port interface-list