Enable Mstp On The Device; Enable/Disable Mstp On A Port - Huawei Quidway S6500 Series Operation Manual

Operation Manual - STP
Quidway S6500 Series Ethernet Switches
more (as if the link to the port is disconnected). If the port has not received any
higher-priority BPDU for a certain period of time thereafter, it will resume the normal
state.
When configure a port, only one configuration can be effective among loop protection,
Root protection and Edge port configuration at same moment.
By default, the switch does not enable BPDU protection or Root protection.
By default, the protection from TC-BPDU packet attack is enabled.
For more about the configuration commands, refer to the Command Manual.

1.2.16 Enable MSTP on the Device

You can use the following command to enable MSTP on the device.
Perform the following configuration in system view.
Table 1-26 Enable/Disable MSTP on a device
Enable MSTP on a device.
Disable MSTP on a device.
Restore the disable state of MSTP, as defaulted.
Only if MSTP has been enabled on the device will other MSTP configurations take
effect.
By default, MSTP is disabled.

1.2.17 Enable/Disable MSTP on a Port

You can use the following command to enable/disable MSTP on a port. You may
disable MSTP on some Ethernet ports of a switch to spare them from spanning tree
calculation. This is a measure to flexibly control MSTP operation and save the CPU
resources of the switch.
MSTP can be enabled/disabled on a port through the following ways.
I. Configure in system view
Perform the following configuration in system view.
Operation
Huawei Technologies Proprietary
1-28
Chapter 1 MSTP Region-configuration
Command
stp enable
stp disable
undo stp