Huawei Quidway S6500 Series Operation Manual page 96

Operation Manual - Network Protocol
Quidway S6500 Series Ethernet Switches
1.3 Display and debug IP Address
After the above configuration, execute display command in any view to display the IP
addresses configured on interfaces of the network device, and to verify the effect of the
configuration.
Table 1-4 Display and debug IP address
Display the configurations of each
interface
1.4 IP Address Configuration Example
I. Networking requirements
Configure the IP address as 129.2.2.1 and sub-net mask as 255.255.255.0 for the
VLAN interface 1 of the Ethernet Switch.
II. Networking diagram
PC PC
Figure 1-3 IP address configuration networking
III. Configuration procedure
# Enter VLAN interface 1.
[Quidway] interface vlan-interface 1
# Configure the IP address for VLAN interface 1.
[Quidway-vlan-interface1] ip address 129.2.2.1 255.255.255.0
1.5 Troubleshoot IP Address Configuration
Fault 1: The Ethernet Switch cannot ping through a certain host in the LAN.
Operation
Switch Switch
Console cable Console cable
Huawei Technologies Proprietary
1-5
Chapter 1 IP Address Configuration
Command
display ip interface [ interface_type
interface_num | brief ]