Huawei Quidway S6500 Series Operation Manual page 567

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches
Table 4-34 Enabling/disabling info-center
Enable info-center
Disable info-center
Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
2) Configuring to output information to log buffer
Perform the following operation in system view.
Table 4-35 Configuring to output information to log buffer
Output information to log buffer
Cancel the configuration of outputting
information to log buffer
3) Configuring information source on the switch
By this configuration, you can define the information that sent to log buffer is generated
by which modules, information type, information level, and so on.
Perform the following operation in system view:
Table 4-36 Defining information source
Define information source
Cancel the configuration
of information source
modu-name specifies the module name; default represents all the modules; level
refers to the severity levels; severity specifies the severity level of information. The
Operation
Operation
Operation
info-center source { modu-name | default } channel
{ channel-number | channel-name } [ { log | trap |
debug }* { level severity | state state }* ]
undo info-center source { modu-name | default }
channel { channel-number | channel-name }
Huawei Technologies Proprietary
Chapter 4 System Maintenance and Debugging
info-center enable
undo info-center enable
info-center
{ channel-number | channel-name } ]
[ size buffersize ]
undo info-center logbuffer [ channel |
size ]
Command
4-22
Command
Command
logbuffer [ channel