Huawei Quidway S6500 Series Operation Manual page 242

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
Perform the following configurations in BGP view.
Table 6-24 Configuring not to syncronize with IGP
cancel the synchronization of BGP and IGP
By default, BGP doesn't synchronize with IGP. Quidway S6500 series ethernet
switches don't support synchronization of BGP and IGP.
6.2.7 Configuring BGP Route Summarization
The CIDR supports route summarization. There are two modes of BGP route
summarization:
summary: The summary of the BGP subnet routes. After the configuration of the
summary, the BGP will not advertise subnets imported by the IGP;
aggregate: the aggregate is the aggregation of the BGP local routes. A series of
parameters can be configured in the aggregate. In general, the preference of the
aggregation is higher than that of the summarization.
Please perform the following configuration in the BGP view:
Table 6-25 Configuring BGP route summarization
Configure
function of the subnet routes
Cancel the summary automatic function
of the subnet routes
Configure
function
Cancel local route aggregation function
By default, the BGP will not perform local route aggregation.
Operation
Operation
the summary automatic
local route aggregation
Huawei Technologies Proprietary
6-15
Chapter 6 BGP Configuration
Command
undo synchronization
Command
summary
undo summary
aggregate address mask
attribute-policy route-policy-name
detail-suppressed
route-policy-name | suppress-policy
route-policy-name ]*
undo aggregate address mask [ as-set
| attribute-policy route-policy-name |
detail-suppressed
route-policy-name | suppress-policy
route-policy-name ]*
[ as-set |
|
| origin-policy
| origin-policy