Huawei Quidway S6500 Series Operation Manual page 224

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
5.3 Displaying and Debugging Integrated IS-IS
Through the following configuration operations, you can view the LSDB of the IS-IS, the
transmitting/receiving of various packets of the IS-IS and the SPF calculation so as to
determine the IS-IS route maintenance conditions.
After the above configuration, execute display command in any view to display the
running of the IS-IS configuration, and to verify the effect of the configuration. Execute
debugging command in user view to debug the IS-IS module.
Table 5-36 Displaying and Debugging IS-IS
View the brief information of IS-IS.
Display IS-IS LSDB
Display IS-IS SPF calculation log
Display IS-IS routing information
Display IS-IS neighbor information
Display mesh group information
Enable IS-IS debugging
Disable IS-IS debugging
Operation
Huawei Technologies Proprietary
5-23
Chapter 5 Integrated IS-IS Configuration
Command
display isis brief
display isis lsdb [ [ l1 | l2 | level-1 |
level-2 ] | [ [ LSPID | local ] | verbose ]* ]*
display isis spf-log
display isis route
display isis peer [ verbose ]
display isis mesh-group
debugging isis { is-adjacency | all |
authentication-error | checksum-error |
circuit-information | configuration-error |
datalink-receiving-packet
datalink-sending-packet | general-error |
interface-information
memory-allocating
receiving-packet-content
self-originate-update
sending-packet-content | snp-packet |
spf-event | spf-summary | spf-timer |
task-error | timer | update-packet }
undo debugging isis { is-adjacency | all |
authentication-error | checksum-error |
circuit-information | configuration-error |
datalink-receiving-packet
datalink-sending-packet | general-error |
interface-information
memory-allocating
receiving-packet-content
self-originate-update
sending-packet-content | snp-packet |
spf-event | spf-summary | spf-timer |
task-error | timer | update-packet }
|
|
|
|
|
|
|
|
|
|