Specify The Switch Type - Huawei Quidway S6500 Series Operation Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches
Table 3-9 Enable/Disable RDRAM
Enable RDRAM of the device
Disable RDRAM of the device
By default, RDRAM of the device is enabled.

3.3 Specify the Switch Type

Using the product command, you can specify the switch type.
If the Salience III series engines works with the S6503 chassis without the XGbus
silkscreen, the system cannot recognize the current switch type. And then you need to
specify the switch type to S6503 by the product 6503 command. After that, if you want
to use this engine in the S6506 chassis without the XGbus silkscreen, you must specify
the switch type to S6506 by the product 6506 command after you insert the engine,
and vice versa.
3.3.1 Specify the Switch Type
Follow these procedures to set the switch type:
Table 3-10 Set the switch type
Configuration item
Enter system view
Set the switch type
Return to user view
Reboot the switch
Note:
You must reboot the switch after specifying the switch type.
If the Salience III series engines works with the other type of chassis, the system
can recognize the current switch type, and this configuration is not needed.
Operation
Command
<Quidway> system-view
[Quidway] product { 6503 |
6506 }
[Quidway] quit
<Quidway> reboot
Huawei Technologies Proprietary
3-5
Chapter 3 Device management
Command
rdram enable
rdram disable
Description
-
Required.
By default, the switch type
is S6506.
-
Required