Configuration Examples Of Sending Log To Unix Loghost - Huawei Quidway S6500 Series Operation Manual

Operation Manual - System Management
Quidway S6500 Series Ethernet Switches
Clear information in memory buffer
Clear information in trap buffer

4.5.11 Configuration examples of sending log to Unix loghost

I. Networking Requirement
The networking requirement are as follows:
Sending the log information of the switch to Unix loghost
The IP address of the loghost is 202.38.1.10
The information with the severity level above informational will be sent to the
loghost
The output language is English
The modules that allowed to output information are ARP and IP
II. Networking diagram
Switch Switch Switch
Figure 4-2 Schematic diagram of configuration
III. Configuration steps
1) Configuration on the switch
Enabling info-center
[Quidway] info-center enable
# Set the host with the IP address of 202.38.1.10 as the loghost; set the severity level
threshold value as informational, set the output language to English; set that the
modules which are allowed to output information are ARP and IP.
[Quidway] info-center loghost 202.38.1.10 facility local4 language english
[Quidway] info-center source arp channel loghost log level informational
[Quidway] info-center source ip channel loghost log level informational
2) Configuration on the loghost
Operation
Network Network
Huawei Technologies Proprietary
4-29
Chapter 4 System Maintenance and Debugging
Command
reset logbuffer
reset trapbuffer
PC PC