Huawei Quidway S6500 Series Operation Manual page 166

Operation Manual - Routing Protocol
Quidway S6500 Series Ethernet Switches
Table 3-18 Configuring RIP traffic sharing among interfaces
Configuration item
Enter system view
Enter RIP view
Enable
sharing
interfaces
3.3 Displaying and Debugging RIP
After the above configuration, execute display command in any view to display the
running of the RIP configuration, and to verify the effect of the configuration. Execute
debugging command in user view to debug the RIP module. Execute reset command
in RIP view to reset the system configuration parameters of RIP.
Table 3-19 Displaying and debugging RIP
Display the current RIP running state and
configuration information.
Display RIP routing information
Enable the RIP debugging information
Disable the RIP debugging information
Enable the debugging of RIP receiving packet
Disable the debugging of RIP receiving packet
Enable the debugging of RIP sending packet
Disable the debugging of RIP sending packet
Reset the system configuration parameters of RIP
3.4 Typical RIP Configuration Example
3.4.1 Networking requirements
As shown in the following figure, the S6500 Series Ethernet Switches C connects to the
subnet 117.102.0.0 through the Ethernet port. The Ethernet ports of S6500 Series
Ethernet Switches A and Switch B are respectively connected to the network
Command
system-view
rip
RIP traffic
traffic-share-across-
among
interface
Operation
Huawei Technologies Proprietary
3-13
Chapter 3 RIP Configuration
Description
-
-
Required; by default,
traffic sharing
interfaces is disabled
Command
display rip
display rip routing
debugging rip packet
undo debugging rip packet
debugging rip receive
undo debugging
receive
debugging rip send
undo debugging rip send
reset
RIP
among
rip