Huawei Quidway S6500 Series Operation Manual page 633

Operation Manual - PoE
Quidway S6500 Series Ethernet Switches
Num
6
7
8
9
10
11
12
13
14
Operation
Enable
PoE-compatibilit [Quidway]
y detection on enable slot slot-num
the PoE board
[Quidway]
Enter Ethernet
interface-type
port view
interface-number
Enable PoE on [Quidway-EthernetX/0/X]
the port poe enable
Set the
[Quidway-EthernetX/0/X]
maximum PoE
poe
power supplied
max-power
by the port
Set the PoE
[Quidway-EthernetX/0/X]
mode on the
poe mode { signal | spare }
port
Set the PoE [Quidway-EthernetX/0/X]
priority on the poe priority { critical | high
port | low }
Display the PoE
state of a <Quidway> display
specific or all interface { interface-name |
all }
ports of the
switch
Display the PoE
power
<Quidway> display
information of a
interface
specific or all
{ interface-name | all }
ports of the
switch
Display the
<Quidway> display
parameters of
powersupply
PoE power unit
Huawei Technologies Proprietary
Command
poe legacy
interface
max-power
poe
poe
power
poe
1-4
Chapter 1 PoE Configuration
Description
Optional
As a result of this
command, a port view
prompt is displayed,
which varies depending
on the port type you
selected.
Once PoE is enabled on
a board, it is enabled on
all ports of the board by
default, and you can
disable/enable it
individual ports of this
board accordingly.
It is 15400 mW by
default, and you can set
it according to the power
of its PD.
By default, the port
supplies power through
signal lines, and this is
the only PoE power
supply mode supported
by the S6500 series.
It is low by default, and
you can set
accordingly.
You can execute this
command in any view.
You can execute this
command in any view.
You can execute this
command in any view.
on
it